You'd be tough-pressed to tell the variation between true wood ceiling beams and higher-good quality polyurethane seem-alikes. If you want the look of true wood beams without having the difficult labor of installing and finishing them, faux wood beams are the ticket. You can get them in tons of styles and prefinished colors to suit your taste, from rough and rustic to smooth and shapely.
Faux beams are a fraction of the weight of wood, so one person can very easily lift the largest beam, and two individuals can securely maneuver them for the duration of installation. You minimize them with ordinary woodworking saws, and they attach to the ceiling with adhesive and a few screws.
Here's how simple it is to set up a ceiling beam.
What You Need to have
Beams and matching wood filler, obtainable on the web for shipment to your door (Google "faux wood beams") Short pieces of 2x4 to use as mounting blocks 3-inch screws or anchors for attaching 2x4 blocks to ceiling 2-inch screws for attaching beam to blocks Development adhesive this kind of as Liquid Nails Poly or PL Premium PolyOverview
The ceiling beam has a U cross segment, open along the best in which it rests towards the ceiling. To install the beam, you 1st reduce short wood blocks that fit within the U and screw these to the ceiling. Then you apply adhesive to the best edges of the beam, slip it above the blocks and screw the beam to them.
Stage By Phase
Soon after you've planned in which the wood beams will go, just stick to these straightforward actions to set up each beam:
Measure the inside width of the ceiling beam and cut 2x4 blocks to fit. You need about one block for every single 4 feet of beam. Mark where the beam will go on the ceiling utilizing a pair of chalk lines or strips of painter's tape. Attach the 2x4 blocks with screws or anchors every three-6 feet along the lines you have marked. Then you can dust off the chalk line or take away the painter's tape. Mark the beam for cutting. If the wall and ceiling don't kind a proper angle, transfer the angle making use of a sliding T bevel. If the beam extends from wall to wall, mark it about 1/eight inch longer for a snug fit. Cut the faux wood beam to length. Use a electrical power miter noticed, guide miter box or any sharp, fine-tooth woodcutting noticed for a smooth reduce. Dry-fit the lower beam to make sure the length is right. Apply building adhesive along the open prime edges of the beam. With a helper, slip the beam more than the blocks, hold it snugly towards the ceiling, and screw it to every block on every side. Countersink the screws somewhat. Fill the screw holes with matching wood filler. Climb down the ladder, sit back in a relaxed chair and admire the new dimension you have just additional to your area.Ideas for Excellent Final resultsIf achievable, place each 2x4 block on a ceiling joist. Then you can use plain screws to attach them securely and not have to bother with plastic or metal anchors. Cut the ceiling beam slightly long so the ends fit snugly into spot towards the walls. Apply the bead of adhesive toward the within of the wood beam so it isn't going to squeeze outdoors the beam. If some adhesive does squeeze out, very carefully wipe it away. Or, to avoid smearing, allow the adhesive harden very first and then cut it away with a razor or utility knife.More Dimensions
You can do considerably much more than attach faux wood beams to the surface of the ceiling. You can enclose the open side and ends of the beam for a fully reliable search from all angles. You can suspend beams from point to stage to simulate ties or trusses. You can use them vertically to simulate help posts. And you can use faux wood beams and accessories outside as well, for everything from decorative headers and corbels to freestanding pergolas.
Tidak ada komentar:
Posting Komentar